Manley Jumbo Schrimp

Dane techniczne:

  • ALL-TUBE: Vacuum Tube all-triode design
  • Input Tubes: 2 x 12AT7EH large plate Electro-Harmonix Russian
  • Interstage Follower Tubes: 2 x 5670 GE USA dual triodes
  • output Tubes: 2 x 7044 or 5687 GE JAN NOS
  • five Line Level Inputs: unbalanced RCA
  • MUTE switch and Warm-Up muting delay
  • ALPS motorised volume control: Accurate tracking usually within 0.5dB. Smooth operation. (no detents)
  • ALPS balance control: Center detented
  • Record Output: (AKA „TAPE OUT”) Unbalanced RCA jacks, unbuffered, passive (always ON)
  • Main Outputs: Two sets of unbalanced RCA main outs for bi-amping or driving a powered subwoofer
  • Gain: 11.8dB
  • Input Impedance: 250 kOhm
  • Input Sensitivity: 200mV in yields 1V out
  • Maximum Input Level: 5V in produces 1.5% THD at output
  • Frequency Response: 10 Hz – 80 KHz; 20 Hz – 20KHz, -0.3dB
  • Noise Floor: Typically -83 dB 20-20K with volume control fully open
  • Noise Floor: Typically -95 dB A WGT 20-20K with volume control fully open
  • Noise Floor (shorted input): Typically -94 dB 20-20K with volume control fully closed
  • Noise Floor (shorted input): Typically -106 dB A WGT 20-20K with volume control fully closed
  • S/N Ratio: typically 95 dB A WGT 20-20K
  • THD: 0.02% at 1V rms output
  • Output Impedance: 50 Ohms
  • Maximum Output: +23dBu @ 1.5% THD into 100K load (10.9V rms)
  • Maximum Output: +20dBm @ 1.5% THD into 600 Ohm load
  • Badge Lamp: LED illumination
  • RF Remove Control: commands volume control UP/DOWN; uses 9V battery
  • Power Consumption: 55 Watts (485mA @ 120VAC)
  • Operating Mains Voltage: Units are purpose built for original destination country’s mains voltage: 100V, 120V, or 220-240VAC as indicated on the serial number badge. Power transformer must be replaced in order to change mains operating voltage. 120VAC units may NOT be rewired to put the primaries of the power transformer in series for 220-240V operation or a large radiated field of hum will develop. If changing locations/voltages, the power transformer must be replaced with the dedicated one for the voltage at which it will operate.